Konica Electronics Enterprise

We have Staubli Mircon3 Card in Stock suitable for Staubli JC5 and JC6 controllers.

Additional Information:

• Item Code: G-06300

Electronic drive with axis control system for brushless motors.

The full digital motor control performed by a 16 bit microcontroller, allows the maximum flexibility
and suitability of the module.

The PWM controlled IGBTs of the power stage, assure high reliability and maximum efficiency.

Features:

Control system: trapezoidal digital current loop; digital position loop with incremental encoder;
algorithm for the regulation of warp tension in textile applications (on request only).


Protections: phase to phase and phase to ground short circuit on power out; input overundervoltage;
output over current; I2T current limitation; overheating; motor thermal protection.


Alarms: over-undervoltage of internal DC Bus; faulty combination of the hall sensors; position
error greater than the maximum programmable threshold; lack of the encoder signals; fault on
the internal current sensors; motor overheating; CANBUS fault.


Input and Output signals: encoder master, encoder slave; CANBUS; serial port for diagnosis and
update; digital input for motor thermistor.


Status monitor: CANBUS messages, seven segments display and 2 led.


Ratings: supply, three phases 230VAC ± 10%; power, 2.4kW; maximum output current 20A,
ambient temperature 0 ÷ 45°C.

Advantages:
 Low cost;
 High reliability;
 Internal braking resistance with possibility to fit also an external one;
 Programmable transmission ratio;
 Self calibration and watch-dog system;
 PC software for the parameters setting;
 Software for electronic take up or let off operation (for textile) is already available on request.

Additional Information:

• Item Code: G6300

Additional Information:

• Item Code: G-6300